Guangzhou Fengjiu New Energy Technology Co.,Ltd , https://www.flashfishbattery.com
Get fluorite W1 when thinking of the phone, because the style of the box is like a flat, no environmental paper style, looks a lot of fresh, remove the instructions and power supply is outside this host W1 
Appearance is a bit chic, because most of the routers are on the bottom and sides on the heat treatment, and the fluorite is also open on the top. It can be seen that the manufacturers still try to achieve the effect of low temperature, but it is easy to fall into the interior, not Easy to clean; mirror and frosted in the heat section to distinguish, another kind of pretty good; in the top there are three one-button button, respectively, wifi switch, wifi strength switch and a key networking, one-click networking is also the main function of W1 one. 
4lan port +1wan port collocation, power supply and USB interface are also on the back side to ensure multi-line output environment, USB interface later use hard disk and the like can set up data environment. 
The bottom is also a thermal design in multiple locations, honeycomb, four footsteps can enhance the heat output 
Added restart restart button, for this pull off the power to restart the individual believe that this is for the later card brush repair preparation. 
Return to the appearance can see the overall shape is streamlined, thin or very good deal, at the same time that there are two versions of the next w1, black is low for the copper line, the other is the silver line version. 
The control interface is relatively clear, much like the newifi interface used by individuals. After the initial configuration, the user can use this interface to perform connection control and related network viewing. It is worth mentioning that the “route storage†below is prepared for the USB interface. However, it is still not perfected during the closed beta phase. 
Wi-Fi can achieve both standard and wall-to-wall switching. Of course, it can also be implemented in one-button operation of the router. The effect of the actual switch is later tested. 
In the wifi guest mode, users can speed up the adaptation mode and open a new network, which is a bit like opening the 5G Hz mode. Unfortunately, the W1 is still only 2.4G Hz. 
The QoS setting interface can freely distribute network transmission and enhance transmission efficiency. 
Some conventional settings, such as UPnP's plug-and-play function, enable peer-to-peer network connections, DHCP dynamic allocation, and so on, all in terms of the functionality of the router. 
Upgrade W1 uses a local upload upgrade, there is no OTA push, do not know whether the late manufacturers will add this feature, of course, there is no plug-in is found throughout, as smart devices can only hope that the manufacturers added after the end of the beta. 
In this interface, you can see the use of fluorite series. It is precisely the smart home mentioned above. W1 is only one of the transmitters. Users still operate other devices through W1 and build their own intelligent system. 
Since it is a router, or test its own wifi effect, because if the later with their own products will not be gathered together, but assigned to multiple locations, so whether to receive good W1 need to test.
Network: Telecom 20M
Wifi settings: wall mode
Receiving device: charm blue note
Comparison equipment: Lenovo newifi
The following test signal diagrams are arranged in AF order
The approximate length of the relevant distance emission point is approximately:
A: 1.4m; B: 3.6m (not including the wall 25cm);
C: 3m (not including the wall 85cm); D: 5.3m (not including the wall 25cm + 85cm);
E: 8.4m (not including wall 25cm); F: 12.3m (not including wall 25cm) 
Test point A, both above -30dbm, there is no concern from the network, fluorite W1 fluctuations more than newifi 
Test point B, the difference between the two below the wall is not too much, fluorite W1 fluctuations are fairly stable 
At test point C, you can see that the signal strength of fluorite W1 is slightly weaker than newifi, but its own stability is much, there is not much fluctuation 
Test point D, fluorite W1 is still lower, its stability is still better than newifi, occasionally dropped when using a network connection 
Test point E, fluorite W1 stability is better than newifi, but its own network transmission is worse than newifi, no effect when used, which is the same as the above test results but the reasons for the thickness of the wall 
At test point F, there was a large fluctuation in the stability of the fluorite W1. Both routers could not be used, and the connection signal was in a virtual state. 
The last thing that comes with the comparison is the contrast between the fluorite W1 open-through mode and the standard mode at test point F. It can be clearly compared that the fluorite W1 is kept at -83dbm in the standard mode and can be maintained at -72dbm in the wall-through mode. Still very significant. 
With the effect of the attached network, the second LED indicator will show green and yellow lights when the fluorite W1 open standard and the wall switch. 
As for the power consumption of the fluorite W1 when the wifi is turned on and off, the power consumption of the fluorite W1 is 3.1w and 4.2w. 
For smart routers, the operation on the mobile phone is also a must. The fluorite W1 mobile phone app interface can only be said to be normal. It is a universal version, which is to bind multiple devices of their own, so that the benefits can be unified management, not good The place is a single setting somewhat boring, W1 can achieve a key switch strength and switch wifi in the phone. Tucao wifi network switch function, speechless boring design, need to manually open after closing, what is the significance of this switch? 
It means a bit remote video, of course, watching some of the same city or shared place, if you have a camera can also be viewed after binding 
Summarized, after getting the fluorite W1, individuals did not think of the main direction of this router, but when used, it was found to be a transit station in the smart series, because Haikang still wanted to make the fluorite series an intelligent platform, including many The sharing of equipment, remote operation, to facilitate the user's life, personally agree with this, for the fluorite W1 this router because it is a closed beta version of the engineering machine, so some of their own shortcomings can still be understood, such as the above The imperfections in the mobile app, router disconnection during use, and interface dispersal, etc., these can still be slowly modified in the later period, specifically to see the official version of the listing, after all, for a engineering machine in terms of fluorite W1 It's pretty good.