The fourth member meeting of the Semiconductor Lighting Technology Standards Working Group of the Ministry of Information Industry was successfully held

The fourth member meeting of the Semiconductor Lighting Technology Standards Working Group was held in Shenzhen. Han Jun, deputy director of the Department of Science and Technology, Ding Wenwu, deputy director of the Electronic Information Product Management Department and the head of the semiconductor lighting technology standards working group, attended the meeting and delivered a speech. Deputy Director of the Institute of Electronic Standardization Zhang Hongtu, Deputy Secretary-General of China Electronics Standardization Technology Association Pang Chunlin, 38 representatives of 29 member units of the Semiconductor Lighting Technology Standards Working Group (hereinafter referred to as the Working Group), and the Science and Technology Department and Product Division of the Ministry of Information Industry, Relevant personnel from the Institute of Electronic Standardization and the China Light and Power Standards Association attended the meeting.
Deputy Director Han Jun proposed to firmly establish the purpose and concept of service for industrial development in the process of standard research and development, to promote independent innovation, to integrate with industrial policy and industrial development; to grasp the field according to current industry development trends Standardized research is required to accelerate the development of semiconductor lighting technology standards. Deputy Director Ding Wenwu clarified the work content and requirements of this meeting, reviewed and affirmed the work done by the working group for more than two years, and hoped that everyone would do their due diligence and do a good job in the preparation of relevant standards to promote industrial development; On the basis of extensive solicitation of comments on standard texts, trials are submitted as soon as possible for relatively mature standards. All member units are required to use the powers conferred in accordance with the requirements of the working group's articles of association, perform their prescribed duties, and assume corresponding obligations.

After careful discussion, the meeting agreed that the seven semiconductor lighting technology electronics industry standards could be submitted for review. The meeting also studied the work in 2008. The working group will convene a working group meeting in April 2008 to identify new work items and commitment units.

The Standards for Semiconductor Lighting Technology Standards Working Group of the Ministry of Information Industry

According to Xinke Han [2007] No. 21 “Notice on the release of the first batch of electronic industry standard research plans for 2007”, the Semiconductor Lighting Technical Standards Working Group is responsible for the formulation of the following standards:
Project number project name

S07006-T

Semiconductor lighting terms and definitions

S07007-T

Semiconductor optoelectronic device small power LED blank detail specification

S07008-T

Phosphor for semiconductor light-emitting diode

S07009-T

Semiconductor light emitting diode chip test method

S070010-T

Sapphire substrate for gallium nitride based light emitting diode

S070011-T

Semiconductor light-emitting diode product series spectrum

S070012-T

Power semiconductor light-emitting diode chip specification

2008 Recommended Standards Project of the Semiconductor Lighting Technology Standards Working Group of the Ministry of Information Industry

——Characterization and testing method of “thermal characteristics” of chip——Test method of “quantum efficiency” of phosphor——LED light radiation test method——LED accelerated life test method——LED module test method——LED energy efficiency——small Dimensional LED backlight - medium size LED backlight - LED control, drive circuit - epitaxial wafer test method - low power chip specification - LED flash for photography - LED light source for photography - LED model nomenclature

General Purpose Steel Wire Rope

Aircraft Cable And GP Steel Wire Rope

Widely used in the industry of Port Machinery, Vessels, Elevators, Engineering Machinery, Mining, Petroleum, etc
GAC: 7x7 7x19
GP steel wire rope: 1x7 1x19 6x7 7x7 6x19 7x19 6x12 6x24 6x37
Surface: (1) hot-dip galvanized; (2) electric galvanized; (3) black; (4) PVC coating; (5) stainless steel; (6) zinc + aluminum, etc.

Steel Wire Rope,Galvanized Wire Rope,Galvanized Steel Wire Rope,Galvanized Aircraft Cable

ROYAL RANGE INTERNATIONAL TRADING CO., LTD , https://www.royalrangelgs.com